BACK TO PREVIOUS PAGE
Tough Coatβ„’
Tough Coat

Tough Coatβ„’

Fusionβ„’ Mineral Paint is famous for its built-in topcoat due to the 100% acrylic resin giving the best adhesion, and long-term durability againstΒ wear and tear. Fusion Mineral Paint is water resistant and a non-porous with its built in top coat of acrylic, however if you want to change the sheen or add a little peace of mind for extra durability over high-traffic areas such as kitchen cabinets or tabletops, you may add a top coat if you wish. This is where ourΒ Tough Coatβ„’Β comes into play!Β Tough Coatβ„’Β uses only 100% acrylic resin and is perfect as a topcoat sealer for those high trafficΒ surfaces such as tabletops, seating, and doors and comes in matte or gloss. Fusionβ„’Β Tough Coatβ„’Β is a true Non Yellowing Clear Top Coat and differs from our competition with its use of pure non-yellowing acrylic.

WHY FUSION’S TOUGH COAT IS NON-YELLOWING

Normally other products onΒ the market use lower quality acrylic resins which will yellow and embrittle over time. The image above shows how Fusionℒ’sΒ Tough Coatβ„’Β lasts up to 3 years of UV exposure in comparison to a competitor brand. As you can see, the Fusionβ„’Β Tough Coatβ„’Β maintains its clear transparency while the competitor brand yellowed.

HOW TO APPLY TOUGH COAT

The keys to applyingΒ Tough Coatβ„’Β to your projects are: Use sparingly and work quickly as it dries fast! When applying, do not pass over the same area more than 2-3 times. We recommend using ourΒ applicator spongesΒ for a smooth consistent finish.

If applying to a recently painted surface, allow the surface to dry for 12 hours before applying. For maximum durability, apply two coats waiting 2-4 hours between applications. In humid areas, longer drying times may be required.

Tip: When applied to darker colours apply in this coats to avoid cloudiness. When using gloss imperfections may be more noticeable.

Be sure to gently mix yourΒ Tough Coatβ„’Β by gently rolling it around prior to using it as the matting agent and other ingredients may settle to the bottom. Do not shake vigorously as this will cause air bubbles in your piece that are difficult to remove once applied. If bubbles occur on your piece, simply remove excessΒ Tough Coatβ„’Β from your brush and brush out the bubbles.Β Tough Coatβ„’Β will begin to dry as you’re using it. In order to avoid brush strokes, try not to spend too much time on one spot. Do not back brush (usually no longer than 30 seconds).